Garmin GPSMAP 700 - Alarms

GPSMAP
®
700 Series Owner’s Manual 55
Device Conguration
Showing the Compass Tape on a Chart
The compass tape appears in a row across the top of a chart or a 3D chart view. It shows the current
heading, and an indicator that shows the bearing to the desired course appears while navigating.
1. From the Home screen, select
Charts.
2. Select a chart or a 3D chart view.
3. Select
Menu.
4. Complete an action:
Select Navigation Chart Setup > Overlay Numbers.
Select Fishing Chart Setup > Overlay Numbers.
Select Overlay Numbers.
5. Select
Show Compass Tape.
Using the Speed Filter
The speed lter averages the speed of your boat over a short period of time for smoother speed
values.
1. From the Home screen, select
Congure > System > GPS.
2. Complete an action:
Select Speed Filter > On to keep the speed lter on continuously. Enter the speed lter time
duration and select Done.
Select Speed Filter > Auto to allow the unit to provide the optimal performance as required
by your situation, such as traveling at a constant speed or frequently changing speeds.
Other Vessels
You can show and congure information about other vessels for the Navigation chart, the Fishing
chart, Perspective 3D, or Mariner’s Eye 3D.
NOTE
: To congure Automatic Identication System (AIS) information for other vessels, your
chartplotter must be connected to an external AIS device.
Viewing a List of AIS Targets
See “Viewing a List of AIS Targets” (page 16).
Conguring the Appearance of Other Vessels
NOTE: The Fishing chart and Mariner’s Eye 3D are available with a preprogrammed BlueChart g2
Vision data card.
1. From the Home screen, select
Charts.
2. Select
Navigation Chart, Fishing Chart, Perspective 3D, or Mariner’s Eye 3D.
3. Select
Menu > Other Vessels > Display Setup.
•
•
•
•
•