2.0 — 109 — 12 October 2012
Tracker
Track down an X100
5 Increase the gain as much as possible and scan with the R1 receiver held flat and turning
360° to pick up the first signal pulses.
● Make sure the internal antenna is selected.
● The range of the R1 receiver is wider if you track from an elevation.
● Always hold the R1 receiver in front of you so that the receiver can distinguish
incoming signals from the front and the back.
S
TEP
R
ESULT
:
Each received signal pulse and its strength are shown on the transmitter
bar/received signal strength and indicated with an audible signal.
6 Scan the area to determine the direction with the highest signal strength. If the signal
strength is the same in all directions, reduce the gain with the Increase/decrease gain but-
tons until the received signal strength is half the transmitter bar and repeat the scan.
7 Follow the determined direction and repeat the scan to verify the followed direction.
N
OTE: When you experience difficulties finding the X100 following one direction, it may
help doing the scan from a different location and locating the cross-section between the
new and previously found direction.
To Next Page