2.0 — 133 — 12 October 2012
18
DATALOG VIEWER
18.1 What
Datalog Viewer is software installed on the GCS. Datalog Viewer is used to download the data
from the X100 for image processing and flight analysis.
18.2 Download the log files
P
REREQUISITES
● X100 after flight with battery connected (STANDBY) and GPS antenna removed
● GCS with
○ Flight ended in Horizon
○ Datalog Viewer installed
● Download cable
After a flight, the log files of the flight are still located in the memory of theX100. You need to
download them to your GCS for image processing and flight analysis.
1 Connect the download cable to the serial port on the GCS.
To Next Page
Loading...