Gatewing X100UAS - 10.3 To replace the propeller blades

2.0 — 73 — 12 October 2012
Motor
To replace the propeller blades
3 Check if the propeller blades are still firmly attached to the propeller.
● The propeller blades must be facing backwards.
● The screws on the tips of the propeller blades must be tightened but the blades must
still be able to move.
10.3 To replace the propeller blades
P REREQUISITES
● Screwdriver
● New set of propeller blades
The propeller blades need to be replaced when:
● One of the blades is broken
● The edges of the blades are damaged
1 Using the screwdriver, remove the old propeller blades.
2 Mount the new propeller blades.
● The propeller blades must be facing backwards.
● The screws on the tips of the propeller blades must be tightened but the blades must
still be able to move.