Gatewing X100UAS - 8.2 Mount an eBox in the X100; 8.3 Remove an eBox from the X100

2.0 — 60 — 12 October 2012
eBox
Mount an eBox in the X100
8.2 Mount an eBox in the X100
P REREQUISITES
● X100 body
● eBox
● Ratcheting screwdriver
● 2 nylon screws
The eBox must be mounted correctly in the body of the X100.
1 Connect the pressure connector of the eBox to the pressure tube.
2 Plug the eBox onto the eBox connector in the eBox bay.
3 Using the screwdriver, secure the eBox with the two screws.
8.3 Remove an eBox from the X100
P REREQUISITES
● X100 with mounted eBox
● Ratcheting screwdriver
The eBox must be removed correctly from the X100.
1 Remove the two screws securing the eBox in the eBox bay.
2 Unplug the eBox from the eBox connector.
3 Disconnect the pressure connector from the pressure tube.
Entry Part
A RF connector
B
• Green ON LED
• CONTROL button
•Red READY LED
C GPS connector
D Pressure connector
E eBox connector