Gatewing X100UAS - 21.2.2 Check the pictures on the camera; 21.3 Clearing the site; 21.3.1 Remove a battery from the X100; 21.3.2 Remove an eBox from the X100

2.0 — 186 — 12 October 2012
After the flight
Clearing the site
21.2.2 Check the pictures on the camera
P REREQUISITES
● X100 after flight
● Camera removed from the aircraft
It is important to check the quality of your pictures after a flight. If necessary, you have to repeat
the flight.
1 Check the quality of the pictures taken during the project:
● Brightness on all pictures
● Not too many blurry pictures
● No dirt visible on pictures
R ESULT : If the quality of the pictures suffices, you can use them for file image processing. If
not, recheck your camera settings and repeat the flight.
A FTER C OMPLETING T HIS T ASK : You can copy the pictures from the SD card to your GCS or
local PC.
21.3 Clearing the site
21.3.1 Remove a battery from the X100
P REREQUISITES
● X100 body with mounted battery
1 Remove the top cover from the payload bay of the X100 body.
2 Disconnect the main power connector of the battery from the X100.
3 Remove the battery from the battery compartment in the payload bay.
21.3.2 Remove an eBox from the X100
P REREQUISITES
● X100 with mounted eBox
● Ratcheting screwdriver
The eBox must be removed correctly from the X100.
1 Remove the two screws securing the eBox in the eBox bay.
2 Unplug the eBox from the eBox connector.
3 Disconnect the pressure connector from the pressure tube.