2.0 — 165 — 12 October 2012
Prepare for flight
Launch
19.5.6 Seal the payload bay with the top cover
P
REREQUISITES
● X100 body
● Top cover with plastic screw
● Flat-bladed screwdriver
1 Make sure no connectors or cables are hanging over the edge of the payload bay.
2 Place the top cover on the payload bay of the X100 body.
3 Using the flat-bladed screwdriver, secure the top cover with the plastic screw.
C
AUTION: Tighten it hand-tight, do not overstrain.
19.6 Launch
19.6.1 Assemble the launcher
P
REREQUISITES
● Launcher bag
● Launch area
To Next Page