2.4.22.3 View/Edit Settings (If setting is enabled for IEEE curve)
2.4.22.4 View/Edit Settings (If setting is enabled for DT)
2.4.23 Group 1- Thermal Overload Submenu
2.4.23.1 View/Edit Settings (If Characteristics is disabled)
2.4.23.2 View/Edit Settings (If Characteristics is set as Single)
2.4.24 Group 1- Cold Load Pickup Submenu
2.4.24.1 View/Edit Settings
2.4.24.2 View/Edit Settings (I>1 Function)
2.4.25 Group 1- Undercurrent Submenu
2.4.25.1 View/Edit Settings (If I< Status is disabled)
2.4.25.2 View/Edit Settings (If I< Status is enabled)
2.4.26 Group 1- CB Fail Submenu
2.4.26.1 View/Edit Settings (If CB FAIL Status is disabled)
2.4.26.2 View/Edit Settings (If CB FAIL Status is enabled)
2.4.27 Group 2 Menu
2.4.27.1 View/Edit Settings
To Next Page
Loading...
Need help?
General
