COMMUNICATION
Password protected window for “COMMUNICATION’’ settings i.e. RP1
Address, RP1 Baud Rate, RP1 Parity and RP1 Timesync.
IO CONFIGURATION
Password protected window for “IO CONFIGURATION’’ settings i.e.
Relay, LED G, LED R, AND Logic and Opto I/P.
O/P RELAY CONFIG
Password protected window for “O/P RELAY CONFIGURATION’’
settings i.e. Contact HR/SR, O/P-1 Open Time, O/P-2 Open Time, O/P-
3 Open Time, O/P-4 Open Time, LED G HR/SR, LED R HR/SR, ANDEQ
A Op Time, ANDEQ A Rst Time, ANDEQ B Op Time, ANDEQ B Rst
Time, ANDEQ C Op Time, ANDEQ C Rst Time, ANDEQ D Op Time and
ANDEQ D Rst Time.
DISTURBANCE REC
Password protected window for “DISTURBANCE RECORD” settings
i.e. Trigger Position.
COMMISSION. TEST
Password protected window for “COMMISSIONING TEST” settings i.e.
Test Mode, Test Pattern, Contact Test and Test LEDs.
GROUP 1
Password protected window for “GROUP 1’’ settings i.e. SYSTEM
CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 1 Setting will be seen only when it is enabled and set as
Active Group in Configuration setting.
GROUP 2
Password protected window for
settings i.e. SYSTEM
CONFIG, OVERCURRENT, NEG SEQUENCE O/C, BROKEN
CONDUCTOR, EARTH FAULT 1, EARTH FAULT 2, THERMAL
OVERLOAD, COLD LOAD PICKUP, UNDERCURRENT and CB FAIL.
Note: Group 2 Setting will be seen only when it is enabled and set as
Active Group in Configuration setting.
2.3.3 System Data Menu
2.3.3.1 View / Edit Settings
SYSTEM DATA
Password protected window for “SYSTEM DATA’’ settings i.e.
Language, Description, Model Number, Serial Number, Software
Version, Frequency, USB Address, USB Parity, USB Baud Rate,
Password, Active Group, Opto I/P Status, Relay O/P Status. CB
Open/Close, Opto I/P and Config Port..
Language
English
Read-only
This window shows user interface is in English Language.
To Next Page
Loading...
