GE Agile P153 - Page 64

P50 Agile P153
5 Configuration
P153/EN M/B
5-26
Overcurrent
Enabled
Editable setting
By using the (5) or (6) key, Over Current can be Enabled or
Disabled.
Neg Sequence O/C
Disabled
Editable setting
By using the (5) or (6) key, Negative Sequence O/C can be Enabled
or Disabled.
Broken Conductor
Disabled
Editable setting
By using the (5) or (6) key, Broken conductor can be Enabled or
Disabled.
Earth Fault 1
Enabled
Editable setting
By using the (5) or (6) key, Earth Fault 1 can be Enabled or Disabled.
Earth Fault 2
Enabled
Editable setting
By using the (5) or (6) key, Earth Fault 2 can be Enabled or Disabled.
Thermal Overload
Disabled
Editable setting
By using the (5) or (6) key, Thermal Overload can be Enabled or
Disabled.
Cold Load Pickup
Disabled
Editable setting
By using the (5) or (6) key, Cold Load Pickup can be Enabled or
Disabled.
Measure’t setup
ABC
Editable setting
By using the (5) or (6) key, Measurement Setup can be set as ABC /
RYB.
UnderCurr Prot
Disabled
Editable setting
By using the (5) or (6) key, Under Current Protection can be
Enabled or Disabled.