AquaTrans™ AT600 User’s Manual 1
Chapter 1. General Installation Instructions
Chapter 1. General Installation Instructions
1.1 Introduction
Thank you for purchasing the AT600 ultrasonic flow meter. The AT600 is a clamp-on ultrasonic flow meter
for the measurement of liquid products. It is designed for the industrial applications, including water,
wastewater, steel, campus energy, and others. The AT600 utilizes a new electronics platform and industrial
design to make it extremely simple to install and use in the field.
• So easy to use, it practically installs itself
The AT600 consists of the new AT600 electronics, a metal enclosure, the field proven AT transducer system,
and a clamp-on transducer fixture (see Figure 1 below).
Figure 1: Typical AT600 System Mounted on a Pipe
Electronics
Transducer Cable
Strap
U-Bolt
Power Cable
Fixture
With Transducer Installed
To Next Page
Loading...
