GE AquaTrans AT600 - Chapter 6. Communication; 6.1 MODBUS Protocol

AquaTrans™ AT600 User’s Manual 85
Chapter 4. Initial Setup and Programming
4.7.9 Programming the Fluid Temperature
Select Fluid Temperature in the Sensor Setup menu, and press [√]. The
following screen opens.
Press
[] again, and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Note: Because the meter calculations are based on customer inputs, the
fluid temperature affects the speed of sound used during a
measurement.
Sensor Setup
Traverses
Fluid Type
Fluid Temperature
Transducer Spacing
Fluid Temperature
Fluid Temperature
25.000 °C
Fluid Temperature
UNIT: °C
25.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[