GE AquaTrans AT600 - Starting or Stopping the Totalizer Measurement

AquaTrans™ AT600 User’s Manual 37
Chapter 4. Initial Setup and Programming
4.3.4 Starting or Stopping the Totalizer Measurement
To start or stop totalizer measurements:
From the display, press either the [] or [] keys until the
Start/Stop icon
(either an arrow icon for
Start or a two-bar icon for Stop) is highlighted.
After the value is highlighted, press [
] to start or stop totalizing.
The display icon then changes to indicate the new status (
Start or Stop).
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00