GE AquaTrans AT600 - User Preferences; Setting

AquaTrans™ AT600 User’s Manual 43
Chapter 4. Initial Setup and Programming
4.5 User Preferences
4.5.1 Setting
To check or change the desired settings, under User Preference, select
Settings and press []. The following screen opens.
To check the
Meter Tag and/or Label, highlight your choice on the Setting
menu and press []. Press [] to return to the previous screen.
Note: You can only change the
Meter Tag and Label data using BHGE’s
Vitality software.
To check or change the date/time, highlight
System Date and press []. The
following screen opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
User Preference
Units Setting
Density
Password
Setting
System Date
Setting
Meter Tag
Label
System Date
Setting
Meter Tag
Label
Set System Time
Date: 11 / 12 / 2013
Time: 08 : 09 : 10
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[