GE AquaTrans AT600 - Sensor Setup

Chapter 4. Initial Setup and Programming
66 AquaTrans™ AT600 User’s Manual
4.7 Sensor Setup
To access the Sensor Setup menu from the measurement display,
highlight the lock symbol and press [√]. The following screen opens.
Select
Program and press [√]. The following screen opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
In the
User Preference menu, select Units Setting and press the [] key
twice. A screen similar to the following opens.
Select the desired parameter with the [] or [] arrow keys, and press
[] to enter the configuration menu.
Velocity
m/s
0.0
Display
Display Format
Program
Program Review
Keypad Lockout
Enter the password
9999
]MOVE
]UNDO [ ]SAVE
]
]
]
]MODF
User Preference
Settings
Units Setting
Density
Password
Sensor Setup
Meter Setup
Mounting Type
Pipe
Transducer