GE AquaTrans AT600 - Page 77

AquaTrans™ AT600 User’s Manual 65
Chapter 4. Initial Setup and Programming
Setting the HART Address
To set the
HART address, select Address and press []. A screen similar to
the following opens.
Press
[] again, and a screen similar to the following opens.
The default setting is 0. Use the [] or [] key to select a specific digit,
then use the [] or [] key to change that digit as required. After all
digits are correct, press
[] to save. Then, press [] to return to the
previous screen.
HART
Address
Address
Address
0
Address
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[