GE AquaTrans AT600 - 4.7.10 Calculating Path (Clamp-on)

Chapter 4. Initial Setup and Programming
74 AquaTrans™ AT600 User’s Manual
4.7.4.3 Setting the Pipe Lining (cont.)
4.7.5 Programming the Transducer when Clamp-on selected
4.7.5.1 Entering a Standard Transducer
Press [] again, and a screen similar to the following opens.
Note: The units shown are the units selected in the
Units Setting menu.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Select
Transducer and press [√]. The following screen opens.
Select
STD and press [√]. A screen similar to the following opens.
Lining SOS
Lining SOS
2000.000 m/s
Lining SOS
UNIT: m/s
2000.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Sensor Setup
Meter Setup
Pipe
Transducer
Mounting Type
Transducer
SPEC
STD
SPEC