GE AquaTrans AT600 - 4.7.11 Entering Path (Wetted)

AquaTrans™ AT600 User’s Manual 75
Chapter 4. Initial Setup and Programming
4.7.5.1 Entering a Standard Transducer (cont.)
Press [] again, and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Note: The available AT600 standard transducers are listed in Table 5
below.
Table 5: Standard Transducer Types
Transducer Number Transducer Type
10 CPT-0.5CPT-0.5
11 CPT-2.0
12 CPT-0.5-MT C-PB-05-M
13 CPT-1.0-MT C-PB-10-M
14 CPT-2.0-MT C-PB-20-M
15 CPT-0.5-HT
16 CPT-1.0-HT
17 CPT-2.0-HT
18 CPS-0.5
19 CPSM-2.0
20 CTS-1.0
21 CTS-1.0-HT
22 CTS-2.0
23 C-LP-40-HM
24 C-LP-40-NM
25 CPB-0.5-HT
26 CPB-2.0-MT
27 CPB-0.5-MT
28 CPB-2.0
29 CPB-0.5
30 CPS-1.0 CPT-1.0
STD
SPEC
STD
0
STD
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[