GE AquaTrans AT600 - 4.6.2 Digital Output Menu Programming

AquaTrans™ AT600 User’s Manual 51
Chapter 4. Initial Setup and Programming
4.6.2 Programming the Digital Output Menu
Digital outputs can be programmed as Pulse, Frequency or Alarm, or they can be turned Off.
To access the
Digital Output menu, on the initial screen, highlight the
lock symbol and press [√]. The following screen opens.
Select
Program and press [√]. The following screen opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
In the
User Preference menu, select Units Setting and press the right arrow
key. A screen similar to the following opens.
Select the desired
Digital Output with the [] or [] arrow keys, and press
[] to enter the relevant configuration menu.
Note: The programming steps for
Digital Output B and Digital Output C are
the same as those for
Digital Output A.
Velocity
m/s
0.0
Display
Display Format
Program
Program Review
Keypad Lockout
Enter the password
9999
]MOVE
]UNDO [ ]SAVE
]
]
]
]MODF
User Preference
Settings
Units Setting
Density
Password
Input/Output
Analog Output A
Digital Output B
Digital Output C
Modbus/Service Port