GE AquaTrans AT600 - 4.6 Inputs;Outputs Configuration; 4.6.1 Analog Output Menu Programming

Chapter 4. Initial Setup and Programming
48 AquaTrans™ AT600 User’s Manual
4.6 Inputs/Outputs
4.6.1 Programming the Analog Output Menu
To access the Analog Output menu, on the initial screen, highlight the
lock symbol and press [√]. The following screen opens.
Select
Program and press [√]. The following screen opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. The following screen opens.
Select
Input/Output and press the [] key. A screen similar to the following
opens.
Select the desired
Output with the [] or [] arrow keys, and press [] to
enter the configuration menu.
Velocity
m/s
0.0
Display
Display Format
Program
Program Review
Keypad Lockout
Enter the password
9999
]MOVE
]UNDO [ ]SAVE
]
]
]
]MODF
User Preference
Settings
Units Setting
Density
Password
Input/Output
Analog Output A
Digital Output B
Digital Output C
Modbus/Service Port