GE AquaTrans AT600 - Page 59

AquaTrans™ AT600 User’s Manual 47
Chapter 4. Initial Setup and Programming
4.5.5.2 Timeout
To provide a timeout, select Timeout and press [√]. A screen similar to the
following opens.
Note: The default value for the timeout is
0.
Press [√] again, and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] three times to return to the User Preference screen.
Display
Backlight
Timeout
Timeout
Timeout
19 S
Timeout
UNIT: S
19
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[