AquaTrans™ AT600 User’s Manual 31
Chapter 4. Initial Setup and Programming
Chapter 4. Initial Setup and Programming
4.1 Introduction
This chapter provides instructions for programming the AT600 flow meter to place it into service. Before the
AT600 can begin taking measurements, at least the following menus must be programmed:
• “User Preferences” on page 43
• “Inputs/Outputs” on page 48
• “Sensor Setup” on page 66
Refer to the Main Menu map in Figure 30 below, and proceed to the appropriate section for instructions.
Figure 30: Main Menu Map
Display
Main Menu
Display Format
Program
Password
xxxx
User Preferences
Input/Output
Sensor Setup
Calibration
Advanced Factory
Program Review Keypad Lockout
Language
Save Changes?
No
Yes
Display
To Next Page
Loading...
