GE AquaTrans AT600 - Enter the Path When Wetted Selected

AquaTrans™ AT600 User’s Manual 87
Chapter 4. Initial Setup and Programming
4.7.11 Enter the Path when Wetted selected
IMPORTANT: Changing the transducer spacing should only be completed according to instructions received
from the factory.
Select
Path and press [√]. The following screen opens.
In the Sensor Setup menu, select Path Length or Axial Length and press
[√]. A screen similar to the following opens.
Press [√] again. Enter this Path use in installing your transducers on the
pipe. The calculation is based on your
Sensor Setup input (pipe,
transducer, fluid, and traverses).
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Sensor Setup
Traverses
Fluid Type
Fluid Temperature
Path
Path
Path Length
Axial Length
Path
Path Length
0.000 mm
Path Length
UNIT: mm
0.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[