GE AquaTrans AT600 - Changing the Measurement Type for One- or Two-Variable Screens

Chapter 4. Initial Setup and Programming
34 AquaTrans™ AT600 User’s Manual
4.3.1 Changing Display for One- or Two-Variable Screens (cont.)
4.3.2 Changing the Measurement Type for One- or Two-Variable Screens
To change the measurement type:
Note: To select a particular measurement unit, go to “Units Setting” on page 44.
Use the [] and [] keys to scroll to the desired value. (Available
options include 0, 1, 2, 3, 4, and Sci (Scientific Notation). Press [
] to
select the value, and then press [
] again to confirm the selection or []
t
o cancel the selection.
From the display screen, press either the [] or [] keys until the
measurement type is highlighted.
After the value is highlighted, press
[] to open the Measurement Type
option.
The screen changes to Display/Measurement Type. Press the [] and []
keys to scroll to the desired parameter. Available parameters include:
Velocity, Act Volumetric, Std volumetric, Mass, Batch Totals, Inventory
Totals, Soundspeed, Reynolds, KFactor, and Diagnostics. After you have
chosen the measurement type, press
[] to select the value, and then
press [
] again to confirm the selection or [] to cancel the selection.
Display/Decimal
2
3
4
Sci
Velocity
m/s
0.0
m/s
Velocity
0.000e+00
Velocity
Measurement Type
Act Volumetric
Std Volumetric
Mass