GE AquaTrans AT600 - Changing the Measurement Type or Units for the Totalizer Screens

AquaTrans™ AT600 User’s Manual 35
Chapter 4. Initial Setup and Programming
4.3.3 Changing the Measurement Type or Units for the Totalizer Screens
The totalizer screen opens similar to Figure 32 below.
Figure 32: The Totalizer Screen
To change the number of decimal places in the value displayed on a totalizer screen, proceed as follows:
From the display screen, press either the [] or [] keys until the value
is highlighted.
After the value is highlighted, press
[] to open the Display/Decimal option.
Use the [] and [] keys to scroll to the desired number of decimal
places. (Available options include 0, 1, 2, 3, 4, and Sci (Scientific Notation).
Press [
] to select the value, and then press [] again to confirm the
selection or
[] to cancel the selection.
Total m^3
Forward 0.000e+00
Reverse 0.000e+00
Totalizer
Reset Totalizer
Error Code
Values
Measurement Type
Start/Stop Totalizer
Totalizer Units
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
Total m^3
Forward 0.000e+00
Reverse 0.000e+00
Display/Decimal
2
3
4
Sci