GE AquaTrans AT600 - 4.7.9 Programming the Fluid Temperature

AquaTrans™ AT600 User’s Manual 73
Chapter 4. Initial Setup and Programming
4.7.4.3 Setting the Pipe Lining (cont.)
Press [] again, and a screen similar to the following opens.
Note: The units shown are the units selected in the
Units Setting menu.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Select
Lining Material and press [], then select the appropriate option and
press
[]. If your pipe material is not listed (see Table 4 below for the
available options), select
Other and press [√] twice. A screen similar to the
following opens.
Table 4: Pre-Programmed Pipe Lining Materials
Name Lining Material
Tar Epoxy Tar Epoxy
Pyrex Glass Pyrex Glass
Asbestos Cement Asbestos Cement
Mortar Mortar
Rubber Rubber
Teflon Teflon (PFTE)
Lining Thickness
Lining Thickness
0.000 mm
Lining Thickness
UNIT: mm
0.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Lining Material
MORTR
RUBBR
REFLN
Other