GE AquaTrans AT600 - 4.7.8 Programming the Fluid Type

Chapter 4. Initial Setup and Programming
72 AquaTrans™ AT600 User’s Manual
4.7.4.2 Setting the Pipe Material (cont.)
4.7.4.3 Setting the Pipe Lining
Press [] again, and a screen similar to the following opens.
Note: The units shown are the units selected in the
Units Setting menu.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
In the
Pipe menu, select Lining and press [√]. The following screen opens.
If there is no lining in your pipe, select
No and press [√] to return to the
previous screen. If your pipe does have a lining, select
Yes and press [√]
twice. A screen similar to the following opens.
To set the lining thickness, select
Lining Thickness and press []. A screen
similar to the following opens.
Pipe SOS
Pipe SOS
2400.000 m/s
Pipe SOS
UNIT: m/s
2400.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Pipe
Pipe ID
Wall Thickness
Pipe Material
Lining
Lining
No
Yes
Lining
Lining Thickness
Lining Material