Chapter 4. Initial Setup and Programming
64 AquaTrans™ AT600 User’s Manual
Selecting the Stop Bits
4.6.4.2 HART
The default Stop Bits is 1. To set the Stop Bits, select Stop Bits and press [].
A screen similar to the following opens.
Select the desired setting and press
[] to return to the previous screen.
To set up
HART communication, select Digital Comm on the Input/Output
screen and press
[]. The following screen opens.
Note: Verify that the
HART function is installed and activated on your
meter.
Press
[] again, and a screen similar to the following opens.
MODBUS
Baud Rate
Address
Bits/Parity
Stop Bits
Digital Output B
Digital Output C
Modbus/Service Port
Digital Comm
To Next Page
Loading...
