AquaTrans™ AT600 User’s Manual 9
Chapter 1. General Installation Instructions
1.8 Mounting the Clamp-on Fixture and Transducer System (cont.)
From the information on the previous page and the documentation included with your AT600 flow meter
system, you should already know the following details about your installation:
• Pipe Size
• Transducer Model
• Transducer Frequency
• Number of Traverses
• Calculated Transducer Spacing
• Number of Clamp-On Fixtures
Based on the known information, proceed directly to one of the following sections in the next chapter for
instructions on installing your AT600 clamp-on fixture(s) and transducers on the pipe:
Note: See the flowchart in Figure 9 on page 10 to assist in choosing the appropriate instructions for your
specific configuration.
• “Transducer Spacing = 32 to 250 mm or 50 to 320 mm, Traverses = 2, Fixtures = 1” on page 11
• “Transducer Spacing = 320 to 940 mm, Traverses = 2, Fixtures = 2” on page 14
• “Transducer Spacing = 0 to 250 mm or 0 to 320 mm, Traverses = 1, Fixtures = 2” on page 17
• “Transducer Spacing >320 mm, Traverses = 1, Fixtures = 2” on page 19
To Next Page
Loading...
