6-4 CASE Revision C
2060290-201
Entering Test Information
Entering Test Information
Overview
Depending on your system configuration, the Test Information window
will open automatically or you can display it with the Test Information
button.
These are the tabs of the menu
Patient Information
Test/Personnel
Medications
AHA Stroke Risk
AHA CHD Risk
Closing a tab with Cancel or OK will bring up the acquisition screen.
Patient Information Tab
The Patient Information tab is open.
1. Verify the patient's name and ID. If the data is incorrect, click
Modify to change.
2. Select the protocol for the next test (refer to section “Protocol Editor
Tab” on page 12-19 for information on changing the default protocol).
3. Confirm or change the Max. predicted HR for the exercise test (refer
to section “Miscellaneous 1 Tab” on page 12-24 for information on
changing the calculation method).
4. Enter the Target HR (%) of the Max. predicted HR (refer to section
“Miscellaneous 1 Tab” on page 12-24 for information on changing the
percentage permanently).
5. Enter a designation for the Room (5 characters max.).
6. Select a Location Number or a Location Name (names can be
configured on the MUSE tab, see “MUSE Tab” on page 12-55).
Note
You can assign a Location Name to the Location number (see section