Revision C CASE 2-5
2060290-201
CASE System
Putting the CASE System Into Service
Connecting the System Components
Warning
Shock Hazard — Only technical staff is authorized to
open the access panel.
1. Connect the cables to the system components and secure the
connections with retaining screws.
2. Guide the cables through the opening in the access panel and connect
them to the appropriate ports as shown on the reference diagram.
3. Close the panel.
Note
Coil the excess cable for storage as shown above. DO NOT squeeze
the cables when closing the access panel.
Cable clamps
Reference
diagram
To Next Page
Loading...
