12-38 CASE Revision C
2060290-201
Custom Setups, Factory Setup
Custom Setups, Factory Setup
The program allows you to save, load, and delete your personal settings
for the different test modalities. From the same menu, you can restore
the factory defaults.
You access the setup menu by clicking the Custom Setup button on the
acquisition or pre-acquisition screen, or from the the General tab of the
System Configuration (see “General Tab” on page 12-40).
Save
1. Click the Save button.
2. In the Save Setup window, select the target drive from the list.
Hard drive
Disk drive A
3. Select a line in the Setup window A.
4. In the Save As box, enter a name.
5. Click Save....
Note
With this command you save the setups of all modalities, not just of
the selected modality.
A Names of stored custom setups.
B Click a button to load, save or delete a setup.
C Click to select the drive.