EasyManua.ls Logo

GE CASE V6.7

GE CASE V6.7
342 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-6 CASE Revision C
2060290-201
Setting Up the Ambulatory Blood Pressure Monitor
6. Select the protocol and click Programming. You can choose between
two protocols. Refer to section “Editing the BP Protocol” on page 12-
32 for information on configuring the protocols.
Note
If you are using TONOPORT V devices, version 2.0 and later,
check the displayed patient data to avoid data mismatch.
7. Turn the monitor off and disconnect it from the PC.
8. Connect the monitor to the patient (see TONOPORT Operator's
Manual).

Table of Contents

Related product manuals