12-44 CASE Revision C
2060290-201
System Configuration
Click New... to display the user registration window.
1. Enter the user name and ID number. If you enter the last name
before the first name, insert a comma in between. Otherwise the
name entered first becomes the first name and the name entered
second becomes the last name, when the user is registered in the
MUSE system. Please note that MUSE accepts first names with a
maximum length of 10 characters, last names must not be longer
than 16 characters. When sending data to a MUSE system, be sure to
match User ID numbers assigned at the MUSE system to User ID
numbers assigned at the CASE unit.
2. Select the user group.
3. Select the user's custom setup (see “Custom Setups, Factory Setup”
on page 12-38).
4. Select the user's privileges.
Edit Data: user is authorized to edit test and patient data.
System Configuration: user is authorized to edit the System
Configuration.
Setup: user is authorized to edit the test settings.
5. Enter a password. Be sure to remember the password. If you forget
it, you will have to contact the GE Healthcare Technical Support or
your local Service Representative.
6. Select the External User check box if you wish to receive data from
remote test stations (at the sending stations, enter the addressee's
name and password).
Note
Do not use any special characters in your passwords. The minimum
length of a password is 6 characters.
To Next Page
Loading...
Need help?
General
