Concord 4 Series Systems 38
Local Phone Control (0210 - 0260)
Phone Options-Partition 1-6(Default = on)
When this feature is on, the panel can be accessed from a phone on the
premises.
To set up Local Phone Control:
1. With the display showing LOCAL PHONE CTRL
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press # and the display shows the new setting.
Remote Access (0211 - 0261)
Phone Options-Partition 1-6 (Default = on)
When this setting is on, the panel can be accessed from an off-site
phone.
To turn Remote Access off or on:
1. With the display showing REMOTE ACCESS
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press # and the display shows the new setting.
Ring/Hang/Ring (0212 - 0262)
Phone Options-Partition 1-6 (Default = on)
This setting determines how the panel picks up (seizes) the phone line. Select
“on” if an answering machine shares the phone line with the panel. Select
“off” if there is no answering machine sharing the phone line with the panel.
Note
The Remote Access setting must be turned on for this feature to work.
When this feature is on, the person who is calling the panel must use the fol-
lowing procedure:
1. Listen for one or two full rings.
2. Hang up.
3. Call the premises again within the next 10–40 seconds. The system
answers after the first ring.
When this feature is off, the system answers after 12 full rings.
To turn Ring/Hang/Ring access off or on:
1. With the display showing RING/HANG/
RING OFF/ON
(current setting), press 1
(off) or 2 (on). The display begins flash-
ing the entered selection.
2. Press # and the display shows the new set-
ting.
Line Fail Delay (partition 1: 0213)
Phone Options-Partition 1 only (Default = none)
This setting determines the amount of time the partition 1
phone line voltage must be absent before the panel indicates
a phone failure trouble condition. If a delay is not pro-
grammed (default), the panel will not monitor the phone line
voltage.
Note
Line Fail Delay is not available for partitions 2-6 at this time.
To set the Line Fail Delay time:
1. With partition 1 selected, press A or B until the display
shows
LINE FAIL DELAY nn SECS (current setting).
2. Enter the desired time value (10–240 seconds). The display
flashes the entered setting. Press # and the display shows
the new setting.
To delete the Line Fail Delay time:
1. With partition 1 selected, press A or B until the display
shows
LINE FAIL DELAY nn SECS (current setting).
2. Press D to delete the current line fail delay time.
Toll Saver (0214 - 0264)
Phone Options-Partition 1-6 (Default = on)
This setting determines whether the panel answers a phone
call on the eighth ring (on) or twelfth ring (off) when a
trouble or alarm condition exists.
To turn Toll Saver off or on:
1. With the desired partition selected, press A or B until the dis-
play shows
TOLL SAVER OFF/ON (current setting).
2.
Press 1 (off) or 2 (on). The display flashes the entered setting.
Press
# and the display shows the new setting.
WWW.DIYALARMFORUM.COM
To Next Page
Loading...
Need help?
General
