Concord 4 Series Systems
43
Touchpad Options Menu
The TOUCHPAD OPTIONS menu lets you set up touchpad panic and arming operation. The fol-
lowing section describes the settings that appear under GLOBAL.
The following sections describe the settings that appear under
PARTITION 1-6.
Latchkey Zones (0500)
Touchpad Options-Global (Default = none)
This setting defines the range of keychain touchpads that
will function as a latchkey user. The value entered in this
section can be any valid zone number. When a zone number
is entered, all zones at or below that zone number will func-
tion as a latchkey user. For example, if 5 is entered, any
keychain touchpads learned into zones 1–5 will be latchkey
users and all others (6–96) will not.
To set the number of Latchkey Zones:
1. With the display showing LATCHKEY ZONES nnn (current set-
ting), enter the desired number of latchkey zones (1–96). The
display flashes the entered setting.
2. Press # and the display shows the new setting.
To delete/disable Latchkey Zones:
1. With the display showing LATCHKEY ZONES nnn (current set-
ting), press D.
Fire Panic (0510 - 0560)
Touchpad Options-Partitions 1-6 (Default = on)
This setting determines whether touchpad fire panic buttons are
enabled (on) or disabled (off).
To change the Fire Panic setting:
1. With the display showing FIRE PANIC OFF/ON
(current setting), press 1 (off) or 2 (on). The dis-
play flashes the entered setting.
2. Press # and the display shows the new setting.
Aux. Panic (0511 - 0561)
Touchpad Options-Partitions 1-6 (Default = on)
This setting determines whether touchpad auxiliary panic buttons are
enabled (on) or disabled (off).
To change the Auxiliary Panic setting:
1. With the display showing AUXILIARY PANIC OFF/
ON
(current setting), press 1 (off) or 2 (on). The
display flashes the entered setting.
2. Press # and the display shows the new setting.
Police Panic (0512 - 0562)
Touchpad Options-Partitions 1-6 (Default = on)
This setting determines whether touchpad police panic buttons are
enabled (on) or disabled (off).
To change the Police Panic setting:
1. With the display showing POLICE PANIC OFF/ON
(current setting), press 1 (off) or 2 (on). The dis-
play flashes the entered setting.
2. Press # and the display shows the new setting.
Keychain TP Arm (0513 - 0563)
Touchpad Options-Partitions 1-6 (Default = off)
When this setting is on, pressing the lock button on keychain touch-
pads arms the system directly to AWAY with NO DELAY.
When this setting is off, each key-press increments the arming level
(i.e., from OFF to STAY, from STAY to AWAY).
To change the Keychain Touchpad Arming setting:
1. With the display showing KEYCHAIN TP ARM OFF/ON
(current setting), press 1 (off) or 2 (on). The display
flashes the entered setting.
2. Press # and the display shows the new setting.
WWW.DIYALARMFORUM.COM
To Next Page
Loading...
Need help?
General
