GE Druck PM 620

Issue 1
2-12 Prepare the instrument K0449 - [EN] English
2.11 Measure and
source operations
When you have set the measure and source functions that you
want to see on the display (see Section 2.10.3), you can
complete these procedures:
• If necessary, change the Process for the CH1 and/or CH2
measure functions: item
This includes: Tare, Alarm, Filter, Flow, Scaling; see
Section 2.11.1
There are more optional Settings for the TC, Frequency, and
RTD functions; see Chapter 3.
• If necessary, change the Automation options for the CH1
and/or CH2 source functions: item
This includes: Nudge, Span Check, Percent Step,
Defined Step, Ramp; see Section 2.11.2
There are more optional Source Settings for the TC,
Frequency, and RTD functions; see Chapter 3.
There are other Settings for Observed functions; see
Section 2.11.3
• If necessary, change the Settings for the pressure function:
item
a. Process (Tare, Alarm, Filter, Flow, Scaling); see
Section 2.11.1
b. Leak Test (Only when the function is set up with this
Utility - Section 2.10.6); for operation, see Chapter 4.
c. Zero; see Chapter 4
• If necessary, change the Configuration: item
This includes: Data Logging (Chapter 6), Documenting
(Chapter 7), and Advanced options (Section 2.12).
• When all the software selections are complete, make the
applicable connections (electrical and/or pressure).
Examples:
a. Electrical and IDOS operations (Chapter 3);
b. Pressure operations with the MC 620 module carrier
(Chapter 4)
1
A
TAP
A
1
B
TAP
B
1
C
C
D
2
1
D