[EN] English - K0449 Pressure indicator operation (MC 620) 4-5
Issue 1
4.4.3 Set the pressure module to zero
Use this option to write a new zero pressure value to the
pressure module you are using.
The sensor adjustment is permitted if it obeys this condition:
Note: To make a temporary adjustment for zero, you can use
the Tare function; see Section 2.11.1
4.4.4 Example procedure: Measure pressure
1. Assemble the pressure indicator with the correct PM 620
modules; see Section 4.2.1.
Adjustment d 10% FS positive pressure value
(for the Sensor)
2
1
3
4
Select Zero Accept the adjustment value
TAP the window
(Maximise)
Select Settings
See the new reading
5
Go back to the Home window.
p1
p2
p1
p2
P2P1
31 2
To Next Page
Loading...
