[EN] English - K0449 Electrical and IDOS operations 3-5
Issue 1
3.2.6 Example procedure: Source DC voltage (CH1)
These examples (A and B) show Channel 1 (CH1) set up to
source a DC voltage.
1. Set the applicable software options; see Section 3.2.1
(Procedure overview).
2. Complete the electrical connections.
3. To continue, set the applicable output value; see
Section 2.11.2.
3.2.7 Example procedure: Measure or source current with internal 24V loop power
These examples (A and B) show Channel 2 (CH2) set up to
measure or source a current with internal loop power (24 V).
21
3
Source DC volts on
channel 1 (CH1)
Range: 0 to 12 V (DC)
Automation: Nudge
(Section 2.11.2)
A
Source DC millivolts on
channel 1 (CH1)
Range: 0 to 2000 mV (DC)
Automation: Nudge
(Section 2.11.2)
B 1
3
2
21
Measure current on
channel 2 (CH2) + internal
loop power (24 V)
Range: ±55 mA
A
Maximum: 24 mA
Source current on
channel 2 (CH2) + internal
loop power (24 V)
Range: 0 to 24 mA
Automation: Nudge
(Section 2.11.2)
2B
3
1
To Next Page
Loading...
