[EN] English - K0449 Electrical and IDOS operations 3-11
Issue 1
3.3.1 Assembly instructions
3.3.2 IDOS function
procedures
When the assembly is complete (Section 3.3.1), you can use
these procedures to measure the pressure with the IDOS
function:
• Set the calibrator functions you want to use on the display;
see Section 2.10.3. This includes:
a. IDOS function (to measure the pressure): item ;
b. other functions (maximum: 6 functions); see Section 3.2
• If necessary, change the Units for the function: item ;
see Section 2.10.5
• If necessary, set a Utility for the function: item ; see
Section 2.10.6
a. Max/Min/Avg
b. Switch Test
Step Procedure
1. Attach one end of the adaptor (IO620-IDOS-USB) to the
applicable IDOS module.
2. On the right-hand side of the instrument (Figure 1-3),
use the rubber recess to pull down the cover for the
connections.
3. Push the Type A end of the adaptor (IO620-IDOS-USB)
into the USB socket on the instrument.
4. Set the instrument power on.
When this symbol flashes at the top of the display, it
shows there is communication between the IDOS
module and the calibrator.
1
2
3
TAP
2
1
3
A
3
C
B
A
B
C
To Next Page
Loading...
