[EN] English - K0449 Pressure indicator operation (MC 620) 4-3
Issue 1
4.4 Measure
pressure
When the pressure indicator assembly is complete
(Section 4.2.1), use the menus to set up the necessary
operations.
4.4.1 Procedure overview
To use the pressure indicator, complete these procedures:
• Set the calibrator functions you want to use on the display;
see Section 2.10.3. This includes:
a. Pressure function (P1 and/or P2): item ;
b. CH1: Channel 1 electrical function (measure or source)
c. CH2: Channel 2 electrical function (measure or source)
d. other functions (maximum: 6 functions)
• If necessary, change the Units for the function: item ;
see Section 2.10.5
• If necessary, set a Utility for the function: item ; see
Section 2.10.6
a. Max/Min/Avg
b. Switch Test
c. Leak Test; see Section 4.4.2
• If necessary, change the Settings for the pressure function:
item
a. Process (Tare, Alarm, Filter, Flow, Scaling);
see Section 2.11.1
b. Leak Test (Only when the Utility is set); see Section 4.4.2
c. Zero. We recommend that you zero a gauge sensor
before you use it; see Section 4.4.3
Step Procedure
4. Re-attach the adaptor to the MC 620 carrier and tighten
it until it is hand tight only.
4
TAP
2
1
3
A
3
C
B
A
B
C
1
D
D
To Next Page
Loading...
