GE Druck PM 620 - Page 71

[EN] English - K0449 HART
®
device operations 8-3
Issue 1
Get extended status info #48 Hart settings menu Common - 5
Write primary variable transducer serial number #49 Hart Sensor Info Common - 5
Read dynamic variable assignments. #50 Advanced device
menu
Common - 5
Write dynamic variable assignments #51 Advanced device
menu
Common - 5
Read max update time period #54 Re-range menu Common - 6
Set poll address #6 Hart settings menu Universal - 5
Read analogue channel additional damping
factor, range values, alarm code & transfer
function
#63 Advanced analogue
menu
Common - 5
Write analogue channel additional damping
factor
#64 Advanced analogue
menu
Common - 5
Write analogue channel range values #65 Advanced analogue
menu
Common - 5
Enter/Exit fixed analogue output mode #66 Loop test Common - 5
Trim analogue channel zero #67 Trim Menu - multiple
output device
Common - 5
Trim analogue channel gain #68 Trim Menu - multiple
output device
Common - 5
Write analogue channel transfer function #69 Analogue channel
info
Common - 5
Get poll address #7 Hart settings menu Universal - 6
Read analogue channel endpoint values #70 Advanced analogue
menu
Common - 5
Lock device for exclusive access #71 Device location
menu
Common - 6
Squawk #72 Device location
menu
Common - 6
Find device #73 Device location
menu
Common - 6
Read lock device state #76 Device location
menu
Common - 6
Command name Command
number
Menu Type and
revision level