GERAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
5-80 Section 5-11 - Common Service Desktop (R3 only)
To change the password:
1.) Navigate to Utility (second page) > Service > Utilities > Change Password.
2.) Under User Type, select the user.
NOTE: Before changing the GEService password (the default is SvcForward123$), make sure the
LOGIQ P9/P7 is connected to the network and the agent is configured. The GEService
password is used to perform portions of remote service. If the password is changed and the
system information is not updated, it may slow down remote service. Both file transfer and SSH
depend on the GEService password.
3.) In New Password and Confirm Password, enter the new password.
4.) Click Update Password.
5.) When a SVCService user password has been changed, reboot the LOGIQ P9/P7 to reflect the
password change.
For more information, see:
• Utilities on page 5-73
RISK OF LOSING DATA.
GE WILL NOT BE ABLE TO RECOVER OR RESET CHANGED PASSWORDS.
SECURELY RECORD THE NEW PASSWORD.
To Next Page
Loading...
Need help?
General
