GEDRAFT LOGIQ P9/P7
D
IRECTION 5604324, REVISION 11 DRAFT (JANUARY 24, 2019) SERVICE MANUAL
Chapter 3 - Setup Instructions 3-23
3-7-2-3 During a normal boot, you may observe
A) Power is distributed to Peripherals, Operator Panel (control panel), Monitor, Front-End and
Back-End Processor.
B) The Back-End Processor and rest of the scanner starts with the sequence listed in following steps:
1) “Boot Screen” is displayed.
2) Back-End Processor is turned ON and starts to load the software.
3) The Start Screen (LOGIQ?) is displayed on the monitor.
4) Start-up progress bars indicating software loading procedures, are displayed on the monitor,
as shown in Figure 3-11 below.Start-up progress bars indicating software loading procedures,
Figure 3-11 GE Healthcare wallpaper with progress bar (R1.x.x)
Figure 3-12 GE Healthcare wallpaper with progress bar (R2.x.x and later)
To Next Page
Loading...
