GE MDS ORBIT MCR User Manual

52 MDS Orbit MCR/ECR Technical Manual MDS 05-6632A01, Rev. F
If no password has been previously set, enter the default password (admin) and press ; 4.
otherwise, enter the saved password at the Password: prompt. (Before placing the unit in final
service, it is recommended that the default password be changed to ensure that only authorized
users have access.)
After successful login, the command prompt appears where you may configure and manage a 5.
number of unit settings.
Using the CLI 3.4.3
This section describes how to use the CLI by using an example: changing the name of the unit.
Step 1: Login to the device using the serial console and use the default username admin and the default
password admin.
(none) login: admin
Password:
Welcome to the CLI
admin connected from 127.0.0.1 using console on (none)
Step 2: Instruct the device to enter configuration mode by typing configure and pressing the enter key:
> configure
Entering configuration mode private
Step 3: Change the device name by typing in the following, followed by enter: set system name
Device539
% set system name Device539
Step 4: Verify the change looks correct by reading the data back, using the following, followed by the
enter key: show system name
% show system name
name Device539;
Step 5: Commit the change by typing in the following, followed by the enter key: commit
% commit
Commit complete.
Step 6: Exit the configuration mode by typing the following, followed by the enter key: exit
% exit
Step 7: Exit the login session by typing the following, followed by the enter key: exit
> exit
Device539 login:
Tab Completion Feature
Tab-completion is a powerful feature that presents CLI users with assistance while typing. Depending on
the text that was already entered, tab-completion will display different possible completions. When the
tab key is pressed and no text has been entered, the CLI shows all possible commands that can be typed.
Creating a One-Time Password
To create a one-time recovery password, proceed as follows:
 Upon successful log-in, enter the following command:
> request system recovery one-time-passwords create function <selected function>
ENTER

GE MDS ORBIT MCR Specifications

General

Brand	GE
Model	MDS ORBIT MCR
Category	Network Router
Language	English