GE MDS ORBIT MCR User Manual

MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 53
NOTE A one-time password is automatically generated and displayed on the screen. Copy this
password and save it in the desired location on your PC. There is no way to ever view it again
from the command line console, so be sure it is properly saved.
 To create additional one-time passwords (up to a total of five), repeat the step above.
Deleting a One-Time Password
To remove an existing password from the list, proceed as follows:
Enter the command request system recovery one-time-passwords delete identifier X, where X is a number
from the currently available one-time passwords. This identifier is not reused. If all five passwords have
been created, then ID 1 can be deleted and the next created password will be at ID 6.
The current list of passwords may be viewed by issuing the command show system recovery one-time-
passwords. The following is an example output from that command. On the unit shown, only two
passwords have been stored. Password 1 or 2 can be deleted from this list.
IDENTIFIER FUNCTION STATUS DATE CREATED DATE REVOKED USER
------------------------------------------------------------------------------------------------------------------------------------------------
1 login usable 2012-06-19T00:27:24+00:00
2 login usable 2012-06-19T00:27:25+00:00
CLI Quick Reference Table 3.4.4
Table 3-3 provides a summary listing of commonly needed tasks and the appropriate commands to enter.
The table can be used as a quick reference before consulting the more detailed information, which follows
in this section. Each CLI command is preceded by the symbol > for operational command, or % for a
configuration command.
Table 3-3. CLI Quick Reference Table
If you wish to...
Enter this CLI command:
Create a one-time password
> request system recovery one-time-password create function
<user function>
View all network interface
status and statistics
> show interfaces-state interface
Create a bridge
% set interfaces interface Bridge type bridge
Add the ETH1 interface to a
bridge
% set interfaces interface Bridge bridge-settings members port
ETH1
Remove the ETH1 interface
from a bridge
% delete interfaces interface Bridge bridge-settings members port
ETH1
Set WiFi AP SSID
% set interfaces interface Wi-Fi wifi-config mode access-point ap-
config ap myssid
Enable WiFi WPA2-Personal
security
% set interfaces interface Wi-Fi wifi-config mode access-point ap-
config ap myssid privacy-mode wpa2-personal psk-config psk
mypassphrase encryption ccmp
Enable WiFi SSID
Broadcasting
% set interfaces interface Wi-Fi wifi-config ap-config ap myssid
broadcast-ssid true
View Cell Settings
> show configuration interfaces interface Cell cell-config
Monitor Cell Status
> show interfaces-state interface Cell cell-status | repeat 5
View NxRadio Settings
> show configuration interfaces interface NxRadio nx-config
Monitor NxRadio Status
> show interfaces-state interface NxRadio nx-status | repeat 5
View WiFi Settings
> show configuration interfaces interface Wi-Fi wifi-config

GE MDS ORBIT MCR Specifications

General

Brand	GE
Model	MDS ORBIT MCR
Category	Network Router
Language	English