GE MDS ORBIT MCR User Manual

MDS 05-6632A01, Rev. F MDS Orbit MCR/ECR Technical Manual 77
 Password - For FTP and SFTP, the password on the remote server
 Control Port - For FTP, the TCP control port (advanced setting - use default)
 Data Port - For FTP, the TCP data port (advanced setting - use default)
 Block Size - For TFTP, the block size as defined in RFP 2348 (advanced setting - use default)
 Timeout - For FTP, TFTP, and SFTP, the timeout in seconds (advanced setting - use default)
The following example shows how to have the device download a cell modem firmware image (named
cell-4g5-1.0.2.mpk) from a TFTP server running on a host (address 192.168.1.10) that is accessible from
the MCR (e.g. a locally connected host or remote host accessible via cellular interface). To start
reprogramming the cell modem firmware from the CLI, enter the following command to download the
firmware image from the TFTP server:
> request interfaces interface Cell firmware reprogram filename cell-4g5-1.0.2.mpk manual-
file-server { tftp { address 192.168.1.10 } }
Monitoring - Reprogram
Once the reprogramming is begun, the process may be cancelled by clicking the Cancel
Reprogramming button. The current status of the reprogramming process is displayed on the web page.
Note that the web page does not display the current status if the device has not been instructed to
reprogram (in other words, if the state is “inactive”).
Figure 3-30. Reprogram Cellular Modem Monitoring
The reprogramming status contains the following items:
 Current State – The status of the reprogramming task:
- inactive
- transfering
- processing
- cancelling
- complete
- failure
- cancelled
 Detailed Message – The details regarding the operation, such as “Processing cellular modem
firmware image”

GE MDS ORBIT MCR Specifications

General

Brand	GE
Model	MDS ORBIT MCR
Category	Network Router
Language	English