6-42 CIC Pro™ 2026419-033E
Configuration
alarms. You can configure the multi-patient viewer alarm audio and ADU
window.
If the mirror CIC Pro center is v4.1.1 or earlier, alarms will be visible but not
audible.
If the mirror CIC Pro center is in the same care area, then alarms will be both
audible and visible, and it is not version dependent.
Set up a mirror CIC Pro center
If you are running the CIC Pro center application in either Russian or Spanish, See
Restriction in setting up a mirror CIC Pro center (using a Russian or Spanish CIC Pro
center application) on page 6-42.
If you are running the CIC Pro center application in a language other than Russian or
Spanish, See Set up a mirror CIC Pro center (using a non-Russian and non-Spanish
CIC Pro center application) on page 6-42.
Restriction in setting up a mirror CIC Pro center (using a
Russian or Spanish CIC Pro center application)
1. Do not create a primary and mirror configuration between CIC Pro center
application versions 5.0.7/5.0.8 and 5.1.x, or vice versa. See the table below for
additional clarification.
Set up a mirror CIC Pro center (using a non-Russian and
non-Spanish CIC Pro center application)
Complete the following procedure to set up a mirror CIC Pro center:
1. From the multi-patient viewer, click Setup CIC.
2. Log on to Setup CIC with service access on page 4-5.
3. At the remote CIC Pro center (mirroring the main CIC Pro center), click Setup
CIC > Display Configuration.
NOTE
Auto Display is disabled on the remote CIC Pro center. However, it is still
active on the main CIC Pro center.
Mirror Primary Status
v5.0.7/v5.0.8 v5.0.7/v5.0.8 Supported
v5.1.0 v5.1.0 Supported
v5.0.7/v5.0.8 v5.1.0 Not supported
v5.1.0 v5.0.7/v5.0.8 Not supported
To Next Page
Loading...
Need help?
General
