Troubleshooting
2026419-033E CIC Pro™ 8-17
1. If you would like to configure the system via a service PC, complete the steps to
set up the service PC’s network properties on page 4-8 and connect a crossover
cable from the service PC’s Ethernet port to the CIC Pro center’s IX network
port.
Otherwise, you can Log on to the CIC Pro center as Administrator on page 4-3.
NOTE
While there is no need to log in as administrator, the steps are provided here
so that you do not have to toggle between different access modes.
2. If you have not already logged onto Webmin, Log on to the Webmin service
interface on page 4-7.
3. Click Configuration > Licensing.
4. Scroll down to the bottom of the Add/Remove Feature Activation Codes
window.
5. Click Browse and navigate to the location where you stored the <Serial Number
of CIC Pro center>.txt license activation file on the service PC.
6. Click Upload to load the licenses on this CIC Pro center.
7. Store the media containing the <Serial Number of CIC Pro center>.txt file and
the Activation Code Summary Sheet in a safe and accessible location. In the
event of a system failure, the option activation codes are required for disaster
recovery.
To Next Page
Loading...
Need help?
General
