GFK-2958E RSTi-EP User Manual 15
1.5.3 Cable Protection
The modules listed in the following table do not have a fused sensor/actuator power supply. Here, all
cables to the connected sensors/actuators must be fused corresponding to their conductor cross-
sections (as per Standard DIN EN 60204-1, section 12).
Digital Input, 4 Points, Positive Logic 24VDC, 2,3, or 4 Wire
Digital Input, 8 Points, Positive Logic, 24VDC 2 Wire
Digital Input, 8 Points, Positive Logic, 24VDC 3 Wire
Digital Input, 4 Points, Positive Logic 24VDC, 2,3, or 4 Wire, Time stamp
Digital Input, 4 Points 110/230 VAC (65 – 277 VAC), 2 Wire, Isolated
Digital Output, 4 Points, Positive Logic 24VDC, 0.5A, 2,3, or 4 Wire
Digital Output, 4 Points, Positive Logic 24VDC, 2.0A, 2,3, or 4 Wire
Digital Output, 4 Points, Positive/Negative Logic 24VDC, 2.0A, 2,3, or 4 Wire
Analog Input, 4 Channels Voltage/Current 16 Bits 2, 3, or 4 Wire
Analog Input, 4 Channels Voltage/Current 12 Bits 2, 3, or 4 Wire
2 Channels PWM Output, Positive Logic, 24VDC, 0.5 A
2 Channels PWM Output, Positive Logic, 24VDC, 2 A
1 Channel High Speed Counter, AB 100 kHz 1 DO 24VDC, 0.5A
2 Channel High Speed Counter, AB 100 kHz
2 Channel Frequency Measurement, 100 kHz
1 Channel Serial Communications, 232, 422, 485
1 Channel SSI Encoder, BCD or Gray-Code Format, 5/24 VDC
Potential distribution modules
Power Module, 16 Channels 24VDC Potential Distribution +24 VDC from Input Current Path
Power Module, 16 Channels 24VDC Potential Distribution +24 VDC from Output Current Path
Power Module, 16 Channels 24VDC Potential Distribution +0VDC from Input Current Path
Power Module, 16 Channels 24VDC Potential Distribution +0VDC from Output Current Path
To Next Page
Loading...
